Stucco Repair (Answer)

Hey Decon,
This job will require a few days that does not get below forty degrees and no hard rainfall. You will need to make a trip to the hardware store to get these items:
Material and Tool List
 Latex caulk
 Caulking gun
 Concrete bonding agent (acryl sixty)
 Whitewash brush (using scissors, cut bristles leaving only about two inches of bristles)
 Small paintbrush
 Square trowel (margin trowel)
 Stucco patching compound
 Duct tape
 Plastic garbage bag
 Small bag of dry sand
Use the latex caulk on the cracks that are one-quarter inch or less in width. Fill in the cracks with the caulk and use the trowel to cut off the excess caulk. While the caulk is still wet, apply some of the dry sand, the next day brush off the excess sand.
For larger cracks you will need to prepare the cracks by brushing off the loose plaster, and painting the crack with bonding agent. Dampen the crack with water, and fill in the cracks with stucco patching compound, make sure to mix the compound fairly stiff. After the compound becomes dry to the touch, brush it with the whitewash brush until it blends with its surroundings. To cure the patch, you will need to lightly mist the patch with water, then cut a piece of the garbage bag large enough to cover the repair. Use the duct tape to secure the garbage bag over the repair, and leave it on for four days. If the area is deeper than three eights of an inch, you will need to use the same techniques, but only fill the area about half the depth, let it set for a day, then finish it just like the other repairs.

I hope this helps, good luck with your “Stucco Jewel”.

Thanks for your question.

Please send questions to agarrett54@hotmail.com Please put "Hey Al" in the subject box.